Pens Needed:
1x Bic Stic Grip (same as in ZT Mod by K4S)
2x Flexgrip Ultra with metal tips
1x any grip which is longer than 3.5 cm (i used blue G2)
1x cap from RSVP
Parts: http://i25.tinypic.com/140w040.jpg
1- tip from Flexgripa
2- shortened body from Flexgripa
3- this parts from Bic Stic Grip which connect bodies
4- body from Flexgripa
5- spring from Flexgripa
6- grip G2
7- clicker without clip from Flexgripa
8- cap RSVP
9- extended ink tube from Flexgrip
Tutorial:
1. First we take one body from Flexgrip and cut it when there's a last pit from the tip
3. Connect the shortened body by the part from point 2 to the second one and screw down the metal tip of Flexgrip along with a spring to the shortened one.
4. Put a grip on a front (it's important that it's longer that 3,5cm so it could cover the link)
5. Extend the ink tube from Flexgrip with some other ink tube the same length as the cut body (around 2,8cm), connecting both ink tubes f.e. with a toothpick. Put the extended ink tube to the body.
6. Now the back - cut off the clip from a Flexgrip's clicker using a knife so it looks like this: http://i47.tinypic.com/nvp5s7.jpg
7. Screw shortened clicker to the end of the body.
8. Put some plasticine to the RSVP cap to give the pen some balance. Then put the cap on a clicker.
Length: my - 20cm
COG: it depends on how much plasticine would you take into RSVP cap
Believe me! this pen ROCKS!!!
Enjoy!
PS: for inspiration thanks to Kanonier!!!
Zuletzt geändert von TrattoPPP am 25.11.09 13:54, insgesamt 3-mal geändert.
It's a nice and simple Mod that can still write, but it would be much better if you don't have to take the cap off to retract it in or out. Solve that problem and then it would be a really good one if it still is as stable and noiseless as before^^
:D
